Issues with mapping c3d Vicon data into actor in Motion Builder

Hey everybody

Love the headaches that comes with learning new software!!!

Ive had a lot of trouble mapping markers from the c3d data (from mocapclub.com) onto an actor in motion builder.

The problem is that; when mapped in Tpose there are no problems, but when I change to another take with same marker info (eg. from actorG-Tpose to actorG-Run) it completely fucks the actor up (remember: the floating stomach problem I showed you in class).

I have however found another appraoch: Use the data from mocapdata.com instead..... It is however not a solution to the issue above, but it works because all the c3d data from that page starts with a tpose followed by the action, so you dont have to change takes after mapping the markers - and it works thus far!

Still, if any of you have had the same problem as stated above, and perhaps found a solution, please post it!

And it also works if you import (merge) additional c3d data from mocapdata.com into your scene as a new take.... NICE!!

All those small victories!